textile and led light development

Designing and developing of a puff with led lights

Schematics of circuit for the Manet project

Schematics of the circuit for the Manet project

Schematics of Circuit and arduino code for the Lue project

Schematics of circuit for the Lue project

 

 

int bend1, bend2, temp;

void setup() {
//Serial.begin(9600);        //debug
}

void loop() {
bend1= analogRead(1);
bend1= map(bend1, 0, 1023, 0, 255);
analogWrite(9, bend1);
bend2= analogRead(2);
bend2= map(bend2, 0, 1023, 0, 255);
analogWrite(10, bend2);
temp= analogRead(3);
temp= map(temp, 0, 1023, 0, 255);
//Serial.println(temp);        //debug
temp= map(constrain(temp, 119, 132), 132, 119, 0, 255);    //callibration here
analogWrite(11, temp);
}



Presentasjon av gruppenes prosjekter

Gruppe 1: utvikle en kokong av ull med lys inni. Lyset skal aktiveres ved at man berører og strekker på innsiden av kokongen.

Gruppe 2: Lage et veggpanel/oppslagstavle med forskjellige lys-effekter

Gruppe 3: Lage interaktive puffer som lyser når man sitter på de

Gruppe 4: lage kosebamse som interagerer med en lysende gardin, til et barnerom

Gruppe 5: strikke barne-luer som kommuniserer med hverandre via lys

Gruppe 6: teppe som reagerer på kroppstemperatur og lyser opp ved berøring

Bend sensor activated

Bend sensor relaxed

Temperature sensor in the same circuit

Many leds in series connected to arduino pwm

Do you want to power many leds? You can with this setup have approximately 30 leds per arduino.

 

many leds to arduino pwm circuit

 

Fredrik made a circuit for arduino pwm (dimmer) for 10-15 leds. See image of circuit. To power the circut you need external power (5-12 v transformator ) that you connect to the black round power input on the arduino (left bellow usb).  The external power in to arduino can beused from pin named “Vin” on Duemilla or 9 v on older arduinos (see red cable in image, connected further to + on the bread board). You will also need a transistor connected from one of the pwm pin 9, 10, or 11 (silver round with 3 legs, 2N2222). How to connect see schematics in second image:

Fredrik uses pwm pin 9 (white cable). A potentiometer connected to analogue 0 (zero) controls the resistance and dimming of all the leds). Fredrik recommends 10 leds per transistor and pwm channel. That means that you with 3 pwm channels can power approximataly 30 leds per arduino.

Schematics for circuit:

 

Schematics for powering many leds with arduino

 

Intens jobbing..

Hillevi Munthe på besøk for å presentrere eget prosjekt på Atelier Nord

Nå gjelder det å få en god ide….